Conveyors, ID/FD Fans and Large Ventilators: Artesis e-MCM for Metals and Power Plants
Belt conveyors and boiler fans — hundreds of auxiliaries with high downtime cost. How ESA catches bearings, misalignment and fouling from the motor cabinet.
Мақала орыс тілінде
Мақаланың толық мәтіні қазіргі уақытта орыс тілінде жарияланған. Аударма дайындалуда — толық мәтін үшін орыс нұсқасына өтіңіз.
Орыс тілінде оқу
Metals plants and CHPs in Kazakhstan run hundreds of auxiliary drives — conveyors, ID/FD fans, feeders, cooling pumps. Artesis e-MCM gives continuous monitoring from the MCC; AMT Pro covers the long tail on routes.
Conveyors
Typical faults: bearing wear, misalignment, belt slip, overload, jam — all change motor torque and current. Sensors on dusty gearboxes are costly to maintain. See also jaw crusher / conveyor comparison.
ID/FD fans
Bearing wear (including electrical erosion), rotor fouling imbalance, efficiency loss. Stack with SDT ultrasound and field balancing. Part of 4-method PdM on CHP/metals.
Early signs in current
Rising average current at same duty, torque pulsation at 1× RPM, step change on jam, traffic-light severity + time-to-failure estimate.
Priority
- Production stoppers — main ID/FD fans, export conveyors.
- Fleet of similar motors — AMT Pro route, promote chronic cases to e-MCM.
KEG TRK — Contact