Artesis e-PCM Application Navigator: Pick Your Asset, Read the Right Guide

Artesis e-PCM monitors the generator and prime mover from generator output signals. One product covers five common deployment patterns — this page helps you pick the right guide.

Quick picker

Your asset	Product	Deep dive
Hydro unit, steam turbine	e-PCM	Hydro & steam
Gas turbine (CCGT, cogeneration)	e-PCM	Gas turbines
Wind turbine	e-PCM	Wind farms
Diesel genset (backup)	e-PCM	DGS backup power
Pumps, fans, conveyors (BOP)	e-MCM	Industry map
Route survey	AMT Pro	AMT Pro route
Multi-site fleet	Artesis IoT	Fleet centralisation

One tech — different pain points

Scenario	Main pain	Why e-PCM
Hydro / steam	Block outage	Generator electrical + low-speed drive
Gas	Remote sites, refineries	Retrofit without full CMS
Wind	Nacelle visits	Tower-base install
DGS	Failed start on grid loss	Trend every test run

Station stack

Turbo-generator / DGS / WTG → e-PCM
BOP motors → e-MCM
Route fleet → AMT Pro
→ Artesis IoT / DCS

e-PCM vs vibration

Case	Recommendation
High-speed GT/ST with CMS	Bently on shaft + e-PCM on generator
Small hydro, no CMS	e-PCM as primary online channel
Wind, costly nacelle access	e-PCM first
Critical DGS	e-PCM per unit
Motors only (no generator)	e-MCM, not e-PCM

Getting started

1. Pilot e-PCM on one critical turbo-generator or DGS.
2. Pilot e-MCM on 3–5 BOP drives — 90-day plan.

All e-PCM guides

1. Hydro & steam
2. Gas turbines
3. Wind farms
4. Diesel gensets

Broader map: Artesis by industry.

KEG TRK — official Artesis distributor. e-PCM catalog · Contact