Solutions
Not an industry, not an instrument, but a task: what we diagnose and why it's worth the money
Condition-based bearing lubrication control
Fewer than 40% of bearings reach their design life because of incorrect lubrication. SDT340 LUBExpert combines ultrasonic diagnostics and smart lubrication in one instrument: up to 3-5x bearing life, 30-50% grease savings.
View solution →
Bearing & rotating equipment diagnostics
SDT340 ultrasound hears an incipient bearing defect at stage 1-2 of failure - earlier than vibration analysis can see it. Pairing it with a portable vibration analyzer closes the gap on imbalance, misalignment and gear-mesh defects.
View solution →
Motor condition monitoring
Artesis e-MCM analyzes a motor's supply current and voltage and turns the motor itself into a sensor - no shaft-mounted hardware. It flags deviations 3-6 months before failure, making it economical to monitor the whole fleet instead of just the 15-20% deemed critical.
View solution →
Compressed air, gas & steam leak detection
Up to 30% of compressed air is lost to leaks - a direct hit on the compressor room's electricity bill. SDT ultrasound locates a leak by the noise of escaping gas, while Ion Science PID detectors measure volatile organic compound concentrations where gas composition matters, not just leak location.
View solution →
Oil analysis & tribology
Lubricant passes through every friction zone of a machine and carries a microscopic record of its condition. Oil analysis sees wear particles, contamination and lubricant degradation long before ultrasound hears them or vibration analysis sees them.
View solution →
Electrical inspection & partial discharge
Partial discharge in high-voltage switchgear quietly destroys insulation for years - until it triggers an arc flash. SDT ultrasound hears the discharge from a safe distance through the cabinet door, with no panel opening and no power-down.
View solution →